|
Apr
24
|
1 Brief introduction of GN solids control
We manufacture whole series solids control main equipments in our factory,sowe enjoy a low production cost as well as best quality control.Our factory is located in China iron production center City,which means we can have manychoices for quality raw materials supplier.As an ISO 9001 certified Solidscontrol China manufacturer,and we also introduced ERP factory management, so we control factory production quality very strickly according to international standards.Our goal is to provide best drilling mud system to our worldwide customer.
twin shale shaker
2 Brief introduction of Nov Brandt
NOV Brandt’s Solids Control is one of the most important phases of the drilling process. The primary reason for using mechanical solids control equipment is to remove detrimental drilled solids from the mud system. Mechanical separation of drilled solids is achieved via screen separation and/or accelerated g-force.
Effective solids control permits viscosity and density to be kept within desired levels, which increases the life of pump parts and drill bits and promotes faster penetration rates-all of which decrease the time and expense of drilling. If mud solids are not properly controlled, the density of the mud can increase above the desired weight, which can negatively affect many areas of the drilling process.
3 Nov Brandt solids control equipments compared with GN solids control equipments
Shale shaker is the most important equipment for the solids control system, it is the first phase solids control equipment in the system.
There are almost 13series shale shakers in Nov Brandt, such as VSM300,KING COBRA, Cobra, King cobra venom, mini cobra, etc.
There are two types shale shakers in GN solids control according to vibrating motion, linear motion shale shaker and balance elliptical motion shale shaker.
Particularly ,GNPS series balanced elliptical shale shaker is the fourth generation patented shale shaker introduced by GN and Southwest Petroleum University. It is the top advanced shale shaker in the world.
For more information of GN solids control equipment, pls contact us freely.
No related posts.
Related posts brought to you by Yet Another Related Posts Plugin.
June 11th, 2010 at 8:40 am
[...] the feed chamber of the auger. The slurry strikes an accelerator plate and is forced into the bowl. Centrifugal force causes heavier solids to accumulate inside the bowl while the auger continuously drags them up the [...]
June 21st, 2010 at 1:55 am
[...] shale shaker is design and manufactured by GN solids control, it has some similar components with Brandt King Cobra, but not totally same, we add our own design in it so it became more reasonable and easy [...]
June 22nd, 2010 at 8:49 am
[...] fantastic place is that it can adopt both linear motion and balance elliptical motion without shutting down the shaker. For treating the oil drilling fluids, the balanced elliptical [...]
September 22nd, 2010 at 4:02 am
[...] we need to make two single shakers on the same skid, called tandem shale shaker or twin shale shaker (double shale shaker). It is convenient for transportation. GNZS83-2 tandem [...]
October 25th, 2010 at 12:15 am
[...] these depths, ground is mainly hard rock. Diamond rigs need to drill slowly to lengthen the life of drill bits and rods, which are very [...]
December 25th, 2010 at 8:55 am
[...] solids control produce linear motion mud cleaner and balanced elliptical motion( BEM) mud [...]