GN Desander Desilter

GN can produce 4 inch mud hopper(500x500mm), 6 inch mud hopper(600x600mm,750x750mm), usually we assembly the mixing pump and mud hopper together as a jet mixing unit. It is widely used in our HDD system. A butterfly valve is incorporated in the neck of the hopper to adjust flow and to close off the hopper after use.

mud hopper

 Mud hopper usually used in mud mixing pump, High shearing mixer. Or as separated device matched with pump for bentonite configuration and mixing in mud mixing system. The working condition of mud hopper usually is mud density 1.5~2.8g/cm3, while mud viscosity is 60~120s. This is usual working condition to provide better performance as well as longer use life to save total cost on drilling.

GN mud mixing hopper are widely used in HDD(horizontal directional drilling) and oil gas drilling for bentonite mixing.Mud Mixing unit is combination of drilling mud hopper and centrifugal pumps,it’s mixing force comes from the centrifugal pump.

Derrick 6” mud hopper

 • Required Pressure: 40 to 60 PSI

 • Volume: 1100 to 1400 GPM

 • Solids: 400 to 600 LB/MIN (4 to 6 “100 lb” sacks per minute)

 • Choke Nipple Bore: 1-3/4” (44 mm)

 Dimensions

Width: 25” (635 mm)

 Length: 58-9/16” (1481 mm)

Height: 39” (991 mm)

Weight: 325 lbs (147 kg)

There are three installation method for jet mixing unit. 1 on the same skid of the mud tank 2 on a separate skid and connect the tank by pipe line 3 hoppe on top of the tank, mixing pump on the skid of the tank

For more information of GN mud hopper, welcome to leave us messa

written by GN Desander Desilter \\ tags: jet mixing unit, mixing pump, mud hopper, mud mixing hopper